--- embedaddon/mpd/doc/mpd20.html 2013/07/22 08:44:33 1.1.1.2 +++ embedaddon/mpd/doc/mpd20.html 2021/03/17 00:39:23 1.1.1.4 @@ -6,7 +6,7 @@
-Mpd 5.7 User Manual +Mpd 5.9 User Manual : Configuring Mpd : Link layerActions from list are checked in order of definition until regexp match will be found. Actions processed at three points. First time @@ -107,7 +107,7 @@ human-readable. However, it confuses some broken PPP i
set link fsm-timeout seconds
This command is analogous to the same command at the bundle layer, but it applies to link-layer FSM's such as Link Control Protocol (LCP). -The default is two seconds; normally this value shouldn't be changed.
+The default is two seconds; normally this value should not be changed.set link keep-alive seconds max
This command enables the sending of LCP echo packets on the link.
The first echo packet is sent after seconds
@@ -193,7 +193,7 @@ encryption keys.
Default disable
and accept
.
eap
Extensible Authentication Protocol. For details see -eap.
+the EAP chapter.Default disable
and accept
.
incoming
This option enables the acceptance of incoming connections. @@ -229,7 +229,7 @@ included in each LCP packet we send, which helps detec conditions.
The check-magic
option causes mpd to verify that the peer's
magic number is correct in all received LCP frames.
Some old broken PPP implementations don't handle magic numbers correctly, +
Some old broken PPP implementations do not handle magic numbers correctly, so these options need to be disabled in these cases.
Default for both options is enable
.
Note that the two most common reasons for seeing ``loopback condition @@ -265,7 +265,7 @@ for instance if IAS is used as RADIUS server.
Default disable
.
peer-as-calling
Forces mpd to send remote tunnel address in Calling-Station-Id -instead of addres supplied by remote peer via tunnel (for PPTP and L2TP). +instead of address supplied by remote peer via tunnel (for PPTP and L2TP). Can be enabled for untrusted peers.
Default is disable
.