version 1.1.1.1, 2012/02/21 17:26:11
|
version 1.1.1.2, 2013/07/21 23:54:38
|
Line 79 file does not match to the current running kernel, con
|
Line 79 file does not match to the current running kernel, con
|
not turn on netlink support. |
not turn on netlink support. |
@item --enable-snmp |
@item --enable-snmp |
Enable SNMP support. By default, SNMP support is disabled. |
Enable SNMP support. By default, SNMP support is disabled. |
@item --enable-opaque-lsa | @item --disable-opaque-lsa |
Enable support for Opaque LSAs (RFC2370) in ospfd. | Disable support for Opaque LSAs (RFC2370) in ospfd. |
@item --disable-ospfapi |
@item --disable-ospfapi |
Disable support for OSPF-API, an API to interface directly with ospfd. |
Disable support for OSPF-API, an API to interface directly with ospfd. |
OSPF-API is enabled if --enable-opaque-lsa is set. |
OSPF-API is enabled if --enable-opaque-lsa is set. |
@item --disable-ospfclient |
@item --disable-ospfclient |
Disable building of the example OSPF-API client. |
Disable building of the example OSPF-API client. |
@item --enable-ospf-te | @item --disable-ospf-te |
Enable support for OSPF Traffic Engineering Extension (internet-draft) this | Disable support for OSPF Traffic Engineering Extension (internet-draft) this |
requires support for Opaque LSAs. |
requires support for Opaque LSAs. |
@item --enable-multipath=@var{ARG} |
@item --enable-multipath=@var{ARG} |
Enable support for Equal Cost Multipath. @var{ARG} is the maximum number |
Enable support for Equal Cost Multipath. @var{ARG} is the maximum number |
of ECMP paths to allow, set to 0 to allow unlimited number of paths. |
of ECMP paths to allow, set to 0 to allow unlimited number of paths. |
@item --enable-rtadv | @item --disable-rtadv |
Enable support IPV6 router advertisement in zebra. | Disable support IPV6 router advertisement in zebra. |
| @item --disable-tests |
| Do not build tests. Test programs are built by default, but not ran or |
| installed. They can be excluded from build with this option, which will |
| minimally decrease compile time and overhead. They can always be built and |
| executed at a later time by running @command{make check} in the @file{tests/} |
| subdirectory, even if they're excluded from build. |
@end table |
@end table |
|
|
You may specify any combination of the above options to the configure |
You may specify any combination of the above options to the configure |